Includes 300mL funnel, fritted base and cap, clamp, and alignment sleeve. Glass Vacuum Filter Holders, 47mm are used in vacuum filtration of liquids to produce clarified or particulate-free filtrate or to analyze particulate or biological contamination retained on the filter surface.

Process samples from an in-line system or pressure vessel with this stainless steel holder. Cole-Parmer™ Advantec 301900 Pressure Filtration Holders maximize flow rates by applying positive pressure to the fluid over a broad membrane surface.

For filtration of gases or liquids at inlet pressures of 20 to 700 bar

Filter holders for use with Sartorius Combisart Systems

All-Glass Filter Holder Kit was designed for the filtration of aqueous and organic or corrosive liquids for particulate contamination analysis.

Cannot pressurize unless completely assembled, assuring safe operation

Replacement part for models XX1014700 / XX1014730 / XX1514700 vacuum filter assemblies. Funnel, 300mL for 47mm Glass Vacuum Filter Holders is a graduated funnel made of autoclavable borosilicate glass.

Use to vacuum filter liquids for bacteriological or particulate contamination analysis.

Replacement part for the XX1014700/XX5014700 vacuum filter assemblies. Base and Stopper for 47mm Glass Vacuum Filter Holders is a borosilicate fritted-glass filter holder base with a silicone stopper that is used to connect the filter assembly to the filtering flask or manifold.

Closed unit for particulate or biological contamination analysis

Vacuum filter aqueous, organic, or corrosive liquids for particulate contamination analysis.

Provides support for membrane filters used with Analytical Filter Holder Assemblies. Support Frits are fully autoclavable.

Replacement part for Hazardous Waste Filtration System

A prerequisite for successful work with glass filters is the selection of the right porosity. It is important to select a filter whose largest pore size is slightly below the grain size of the smallest particles still to be separated.

A prerequisite for successful work with glass filters is the selection of the right porosity. It is important to select a filter whose largest pore size is slightly below the grain size of the smallest particles still to be separated.

The micro filter candle is suitable for the extraction of supernatant solutions but also for the separation of solids from a carrier gas.

Ultraclean or sterilize small volumes of liquids dispensed by syringe

Replacement parts for 90 and 142mm stainless-steel filter holders

For the ultimate in convenience and safety. EZ-Pak and Microfil System includes ready-to-use, sterile filtration funnels and a unique filtration support to facilitate sample processing.

Stopper for Vacuum Filtration is designed to replace parts contained in glass vacuum filtration kits or provide for an alternative configuration.

Designated by the US EPA as a suitable apparatus for Toxicity Characteristic Leaching Procedure (TCLP)

Use to vacuum filter liquids for bacteriological or particulate contamination analysis

For vacuum filtration using 96- and 384-well MultiScreen_HTS, MultiScreen™ Solvinert, and Solvinert Deep Well filter plates

Optimal handling for all MicroPlus and ME membrane filters

Vacuum-Type Glass Membrane Holder, glass reservoir, 47 mm, 300 ml volume, membrane filter accessories

MV series vacuum filtration devices are made of stainless steel, which is especially suitable for microbiological applications.

DWK Life Sciences Kimble Kontes Filtration Assemblies: Flasks With Side Arm, No. 2 Hose connection, Capacity: 1000mL, Connector Types: No. 2 Hose Connection, Standard Taper Joint: 8, Borosilicate Glass, Description: Filtration Flask

Components for Ultra-ware™ microfiltration assembly

Designed to handle up to 500 mL of sample liquids for the analysis of particulate or microbiological contamination